Author Message
 Post subject: Fabrication Drawing and hole callout
PostPosted: 22 Sep 2010, 12:48 
Offline

Joined: 26 Jul 2010, 17:00
Posts: 15
I exported a DXF of my Drill_Top layer and imported into SolidWorks with the hopes that I could make a fab drawing. It seems the common look of these is the board with the holes located with symbols. My CAD guy said he couldn't find a way to get SW to automatically place different symbols for the different hole sizes. He said he could do it manually but...

So is there a way to do it currently from DipTrace with some option I need to check? Or some free software to make a fab drawing (hole symbols)?


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 13 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group