Manual routing not snapping to pads

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
jazzjohn
Posts: 59
Joined: 02 Apr 2015, 11:41

Manual routing not snapping to pads

#1 Post by jazzjohn » 11 Oct 2017, 06:16

The layout shows ratlines after renewing the layout from the schematic. However, manual routing doesn't seem to recognize any pads. When starting or ending a trace over a pad, the pad doesn't highlight.

This is a new one to me... Any ideas?

Tomg
Expert
Posts: 2028
Joined: 20 Jun 2015, 07:39

Re: Manual routing not snapping to pads

#2 Post by Tomg » 11 Oct 2017, 06:28

Here's one possible cause...
Attachments
select.gif
select.gif (24.37 KiB) Viewed 155 times
Tom

jazzjohn
Posts: 59
Joined: 02 Apr 2015, 11:41

Re: Manual routing not snapping to pads

#3 Post by jazzjohn » 11 Oct 2017, 07:01

That's it. Thanks!

Post Reply