DipTrace Forum
http://www.diptrace.com/forum/

Stuck in Trace edit mode
http://www.diptrace.com/forum/viewtopic.php?f=4&t=11831
Page 1 of 1

Author:  allenpitts [ 01 Oct 2017, 15:02 ]
Post subject:  Stuck in Trace edit mode

Hello Dip Trace,

In Route > Manual Routing > Edit Trace There are small
squares at the end of two traces. The interface will not
allow the selection or editing of text.
Perhaps something has been clicked that, when the trace is
either right clicked or left clicked, nothing happens.

Gif attached.

Thanks.

Allen in Dallas

Author:  Tomg [ 02 Oct 2017, 06:44 ]
Post subject:  Re: Stuck in Trace edit mode

The small square indicates that there is no connection. Looking at the cursor will usually tell you which mode you are in. You need to exit the Edit Trace mode and return to the Default Mode to work on text. To return to the Default Mode, right-click in an empty section of the Design Area.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/