Author Message
 Post subject: Copper pour not pouring
PostPosted: 07 Feb 2017, 15:17 
Offline

Joined: 23 Sep 2016, 22:31
Posts: 13
I have a small Copper Pour I am trying to put over one of the pins of my SMD IC. I keep getting the error that it cannot pour because of keepouts or other clearance issue.

I've set the pour's net to GND which is the same net that pin is connected to. Nor is the part/component showing any keep-outs or other problem.

What should I look for next?


Top
 Profile  
 
 Post subject: Re: Copper pour not pouring
PostPosted: 07 Feb 2017, 15:47 
Offline
Expert

Joined: 20 Jun 2015, 14:39
Posts: 943
Right-click on the pad and select Thermal Settings... to bring up the Thermal dialog window. If [X] Use Cutsom Settings is enabled, make sure Connect: is set to By Pour for the layer in question. Don't forget to re-pour.

_________________
Tom


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group