DipTrace Forum
http://www.diptrace.com/forum/

What is the best method to transfer the circuit layout ?
http://www.diptrace.com/forum/viewtopic.php?f=4&t=11124
Page 1 of 1

Author:  eletmoraes [ 23 Jun 2016, 19:29 ]
Post subject:  What is the best method to transfer the circuit layout ?

What is the best method to transfer the circuit layout for phenolite plate?

After developing the circuit want to transfer the layout to the virgin printed circuit board, what is the best and most affordable method to transfer, there is a method of laser thermal transfer, dry film, screen printing, etc.

Author:  JoeDini [ 30 Jun 2016, 13:00 ]
Post subject:  Re: What is the best method to transfer the circuit layout

Hi..i am a new user here. As per my experience all the three methods have their own characteristics, properties, pros and cons etc. I would like to suggest you to go for the Screen printing. Because it is most affordable and efficient. But again it depends upon your requirement that what type of design you have and further where do you want to use your board.

Author:  Techno Tronix [ 02 Jul 2016, 05:49 ]
Post subject:  Re: What is the best method to transfer the circuit layout

PCB fabrication method can be use to transfer the circuit layout.

Author:  viya0414 [ 06 Sep 2017, 22:29 ]
Post subject:  Re: What is the best method to transfer the circuit layout

I would like to suggest you to go for the Screen printing. Because it is most affordable and efficient.


pcb manufacturing

Author:  RushPCB.Com [ 20 Sep 2017, 16:46 ]
Post subject:  Re: What is the best method to transfer the circuit layout

You need to transfer your schematic diagram into a drawing of your printed circuit board. Most PCB software will have tools that will help you draw your board from the schematic. PCB fabrication method can also help you with this.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/