Copper pour - unconnected island not removed

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
clarkleach
Posts: 20
Joined: 03 Apr 2014, 15:49

Copper pour - unconnected island not removed

#1 Post by clarkleach » 16 Mar 2017, 10:31

I'm posting this here since there doesn't seem to be a separate forum for bugz...
diptrace-unconnected-island.png
diptrace-unconnected-island.png (8.89 KiB) Viewed 239 times
As you can see, this is clearly an unconnected island - not removed...

Alex
Technical Support
Posts: 3897
Joined: 13 Jun 2010, 23:43

Re: Copper pour - unconnected island not removed

#2 Post by Alex » 17 Mar 2017, 00:51

Please open copper pour properties and make sure you enabled removing unconnected islands. If you did it but islands remain, please upload board file on the forum or send it to support at diptrace dot com.

clarkleach
Posts: 20
Joined: 03 Apr 2014, 15:49

Re: Copper pour - unconnected island not removed

#3 Post by clarkleach » 17 Mar 2017, 04:57

I have sent the dip file to support via e-mail.

Post Reply