DipTrace Forum
http://www.diptrace.com/forum/

Component Editor Pin Properties
http://www.diptrace.com/forum/viewtopic.php?f=3&t=11662
Page 1 of 1

Author:  Fatov [ 03 Jul 2017, 08:31 ]
Post subject:  Component Editor Pin Properties

Hello,
I am creating some custom components and noticed the opportunity for defining the pin type and pin electric in the pin properties menu.
Unfortunately I could not find any information or legend explaining each type.
Is there a documentation which explain each entry in the drop down menu?

Image

Author:  Tomg [ 03 Jul 2017, 09:24 ]
Post subject:  Re: Component Editor Pin Properties

So far this is the only DipTrace documentation I was able to find on the matter...

Pin Type
In the Component Editor click on Help > Component Editor Help then, in the Component Editor Help dialog window, click on [+]Component Editor > [+]Designing the component > [+]Pins > [?]Properties.

Electric Type
In the Schematic Editor click on Help > Schematic Help then, in the Schematic Help dialog window, click on [+]Schematic > [+]Verification > [?]Electrical rule check.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/