DipTrace Forum
http://www.diptrace.com/forum/

Schematic Print thickness is thin !
http://www.diptrace.com/forum/viewtopic.php?f=3&t=11510
Page 1 of 1

Author:  clickshe [ 21 Mar 2017, 12:13 ]
Post subject:  Schematic Print thickness is thin !

Hello
I tried to print schematics, but the thickness is very thin !
Yes, I know that i can increase the thickness from View/Line Width, but if I increase from there:
1 - the component symbols will remain thin
2- the line width will be fat.

Do not tell me that I have to change the thickness to all symbols, because it would be absurd !
Comparing the DipTrace prints with those made with other similar software, those of DipTrace
have a very ugly appearance, and, above all, they are very difficult to read in detail.

Is there a solution that I missed?
Thank you for reading.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/