DipTrace Forum
http://www.diptrace.com/forum/

Pattern Size
http://www.diptrace.com/forum/viewtopic.php?f=3&t=11461
Page 1 of 1

Author:  diode663 [ 26 Feb 2017, 16:03 ]
Post subject:  Pattern Size

Hello, I did a cursory search to try to find an answer to my question but didnt find anything. I was wondering if there was a way to scale the patterns while making a schematic. The sizing of these patterns borders on comical. I have a standard sized ic with a 3x3 inch mosfet. It makes it nearly impossible to fit anything on a sheet of paper to be able to print out your schematic. Thank you.

Author:  Tomg [ 26 Feb 2017, 16:27 ]
Post subject:  Re: Pattern Size

diode663 wrote:
"...I was wondering if there was a way to scale the patterns while making a schematic..."
Not that I know of.

diode663 wrote:
"...I have a standard sized ic with a 3x3 inch mosfet. It makes it nearly impossible to fit anything on a sheet of paper to be able to print out your schematic..."
Where did you find this giant MOSFET and what sheet size have you selected for the Schematic Editor?

In the Schematic Editor, click on File > Preview... and try the settings shown in the screenshot below...

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/