Author Message
 Post subject: Schematic Print thickness is thin !
PostPosted: 21 Mar 2017, 12:13 
Offline

Joined: 04 Mar 2017, 10:43
Posts: 1
Hello
I tried to print schematics, but the thickness is very thin !
Yes, I know that i can increase the thickness from View/Line Width, but if I increase from there:
1 - the component symbols will remain thin
2- the line width will be fat.

Do not tell me that I have to change the thickness to all symbols, because it would be absurd !
Comparing the DipTrace prints with those made with other similar software, those of DipTrace
have a very ugly appearance, and, above all, they are very difficult to read in detail.

Is there a solution that I missed?
Thank you for reading.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group