Author Message
 Post subject: two or three pin header?
PostPosted: 21 May 2016, 18:43 
Offline

Joined: 21 May 2016, 15:40
Posts: 3
I'm using PCB creator and I can't find a schematic symbol for a two pin header (3 will do).

I can make one, but it just feels wrong that it wouldn't already exist.

Is there one? Can someone tell me what library it's in?


Top
 Profile  
 
 Post subject: Re: two or three pin header?
PostPosted: 23 May 2016, 12:29 
Offline
Expert

Joined: 20 Jun 2015, 14:39
Posts: 936
brianmckee wrote:
"...I'm using PCB creator and I can't find a schematic symbol for a two pin header..."
Look in the "Con Headers" library.


You do not have the required permissions to view the files attached to this post.

_________________
Tom


Top
 Profile  
 
 Post subject: Re: two or three pin header?
PostPosted: 23 May 2016, 13:41 
Offline

Joined: 21 May 2016, 15:40
Posts: 3
Thanks for replying.

I'm running PCB Express 2.0, I don't see CON_Headers in the list. I see that DipTrace is up to Rev 3.0. Do you know if it's part of version 3.0 and is PCB Express is going to be upgraded?

Thanks again.


Top
 Profile  
 
 Post subject: Re: two or three pin header?
PostPosted: 23 May 2016, 14:09 
Offline
Expert

Joined: 20 Jun 2015, 14:39
Posts: 936
Sorry. I didn't realize that PCB Creator was an old version of DipTrace. Have you tried loading the optional libraries for PCB Creator from the Bay Area Circuits web site? They can be found here - http://bayareacircuits.com/pcb-creator-libraries/

brianmckee wrote:
"...I see that DipTrace is up to Rev 3.0. Do you know if it's part of version 3.0 and is PCB Express is going to be upgraded?..."
Do you mean PCB Creator? If so, judging by the PCB Creator tutorials on the Bay Area Circuits web site, it is a pre-2.4 version of DipTrace. I don't know what their plans are. You would have to ask someone at DipTrace (Alex or Serg) about that.

_________________
Tom


Top
 Profile  
 
 Post subject: Re: two or three pin header?
PostPosted: 23 May 2016, 16:51 
Offline

Joined: 21 May 2016, 15:40
Posts: 3
Yes. I mean PCB creator.

I haven't tried those libraries because it says at the bottom of the page that they are included. I'll check them out though.

Thanks much.


Top
 Profile  
 
 Post subject: Re: two or three pin header?
PostPosted: 10 Jun 2016, 10:09 
Offline

Joined: 11 Sep 2015, 07:44
Posts: 53
Location: CA
I think you should update PCB express.

_________________
PCB assembly & Fabrication


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 6 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group