Controlling location of part label
-
- Posts: 76
- Joined: 17 Feb 2014, 03:23
Controlling location of part label
I want to do some net ports nut with the label text where I want, but there does not seem to be any control over this so I have to keep pressing F10 and manually moving text on all labels.
Re: Controlling location of part label
Are you saying you want to be able to specify a Part Name location in the Component Editor so you don't have to change it in the Schematic Editor every time?
If so, then +1.
DipTrace needs to have a View>Part Name>Show/Hide/Font submenu added to the Component Editor. (Just like the current View>Pin Numbers>Show/Hide/Font submenu.) This would save everyone from a lot of unnecessary, tedious work during the Schematic creation process.
If so, then +1.
DipTrace needs to have a View>Part Name>Show/Hide/Font submenu added to the Component Editor. (Just like the current View>Pin Numbers>Show/Hide/Font submenu.) This would save everyone from a lot of unnecessary, tedious work during the Schematic creation process.
Tom