Author Message
 Post subject: Grouping error
PostPosted: 05 Dec 2012, 01:07 
Offline

Joined: 14 Jun 2010, 22:29
Posts: 71
Hello DipTrace,

NOTE: Posted in another thread, but this may explain it better from me.

I have this wording grouped together (Garage Door Valet) / (R), with the (R) in a circle place for "Trade Mark". When I make it a rear side view (Bottom Silk), the (R) does not go to the proper side of the Grouping. Instead of staying at the end of the word, it goes to the beginning of the word, even in the 3D mode view mode.

Thanks


Top
 Profile  
 
 Post subject: Re: Grouping error
PostPosted: 06 Dec 2012, 02:30 
Offline
Technical Support

Joined: 14 Jun 2010, 06:43
Posts: 2762
Thank you for the report. If it can be reproduced in the latest version, please send PCB file to support at diptrace dot com.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group