Connecting capacity modules to Weidmueller power supplies

For general questions regarding the software and for all questions that do not fit in any of the threads above.
Post Reply
Message
Author
neoply
Posts: 1
Joined: 23 May 2017, 18:50

Connecting capacity modules to Weidmueller power supplies

#1 Post by neoply » 23 May 2017, 19:07

Hello all. Thanks for taking up your time to read my post.

Image

In power supply catalogue, There is a "Capacity Module" as an expansion module for the power supply to ensure a secure power supply even at peak loads (for example when the motor starts) and the specific triggering of circuit breakers(as the catalogue says). But I cant understand what exactly capacity modules are? are they a solution for bridging short-term power supply failures? How can they be used in triggering specific circuit breaker?

this is the link to the capacity module, R11-4-4.00A-R01CV-V as the datasheet of http://www.kynix.com/uploadfiles/pdf879 ... 01CV-V.pdf for power supply catalogue.

Can anyone help me ? I am very puzzled about this question.

Post Reply