Hi,
I'll be grateful for your assistance in solving this problem please, in the print preview traces are displayed correctly but when I print it (HP P2055dn), corners are not printed correctly. I've tried PCL5, PCL6 and PS drivers and print at maximum density and resolution.
thanks
Paul
Print preview screenshot
Actual print
Please help with printing problem
-
- Posts: 188
- Joined: 09 Jan 2015, 19:00
- Location: Anaheim, CA 92806
- Contact:
Re: Please help with printing problem
Which diptrace version are you using? Please take a look at the Diptrace Tutorial. You will get a solution. http://www.diptrace.com/books/tutorial.pdf
Re: Please help with printing problem
Thanks for your response, I'm using version 3.0.0.2. Could you perhaps be more specific about the tutorial, which section? I don't see anything relevant in the printing section.Techno Tronix wrote:Which diptrace version are you using? Please take a look at the Diptrace Tutorial. You will get a solution. http://www.diptrace.com/books/tutorial.pdf
Re: Please help with printing problem
Please install a virtual PDF printer if your system doesn't have any PDF printer yet and print out your board to PDF printer. If PDF file has the same issue then upload your board on the forum or send it to DipTrace support. But if PDF file is correct then this is your printer problem. You can try to print out PDF file on the printer and see how it works with PDF files.