Author Message
 Post subject: Pads both sides through hole part?
PostPosted: 25 May 2014, 14:49 
Offline

Joined: 25 May 2014, 14:16
Posts: 1
I have tried to create a component which will produce pads on the bottom side of the board only. I can create this type of part and erase the top pad component by component in the routing module which works. Is there a way of creating a component with a bottom side pad pattern in the first place so that when I update the pattern in the routing module using right click>replace pattern that pattern is used. Thanks


Top
 Profile  
 
 Post subject: Re: Pads both sides through hole part?
PostPosted: 08 Jun 2014, 10:57 
Offline

Joined: 21 Dec 2013, 13:31
Posts: 3
In PCB, you can choose which side you want your component pins on. Just click on one of them and select Pad layers.
I could not find a way to save that configuration, however - you might want to make a feature request.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group