Author Message
 Post subject: "Block" PCB Layout
PostPosted: 15 May 2014, 06:06 

Joined: 15 May 2014, 05:36
Posts: 1
So I have this circuit that I have divided into blocks. Although each of the blocks get power from the same lines. Is it possible to reflect this on the PCB layout.
I mean, each of the block would be separated from each other, yet traces that are common to each block, such as for the power, remains unaffected. By the way, I am trying to achieve this on a single board. I guess I could try placing the components manually, segregating them to which block they belong to, but is there a feature in DipTrace will help me do this?

 Post subject: Re: "Block" PCB Layout
PostPosted: 26 May 2014, 13:34 

Joined: 17 May 2014, 17:53
Posts: 9
Sounds like what you want is very similar to rooms in Altium: create a schematic hierarchy and then have the PCB design stage group components based on that.

This way, if you have a special HF circuit, you can put it on one schematic with its (de)coupling caps grouped with the related circuit so initial PCB placement will put them together, put your FPGA/DSP/SoC/whatever in one sheet with their caps (or put the ASICs' local voltage regulators and decoupling in a sub-sheet) so they all get grouped together, etc.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group