Author Message
 Post subject: NO rout below the IC / In between pads (How??)
PostPosted: 29 Nov 2013, 00:35 
Offline

Joined: 20 Nov 2013, 07:24
Posts: 15
In a particular IC pattern that i have created, I don not need any traces below the IC (in between the PADS * *refer the IMAGE). I can achieve it while manual routing, that's an option. While in the Auto-route mode need to achieve it.

looking forward for answers that say how ? can I achive it.

[Things tried -
1. drew a box -
2. went to shape properties
3. TYPE- top KEEPOUT
* It dint help me !! ]


You do not have the required permissions to view the files attached to this post.


Top
 Profile  
 
 Post subject: Re: NO rout below the IC / In between pads (How??)
PostPosted: 29 Nov 2013, 05:37 
Offline
Technical Support

Joined: 14 Jun 2010, 06:43
Posts: 2762
Most probably you created placement keepout. You should use route keepout instead, it will do the job.


Top
 Profile  
 
 Post subject: Re: NO rout below the IC / In between pads (How??)
PostPosted: 02 Dec 2013, 03:33 
Offline

Joined: 20 Nov 2013, 07:24
Posts: 15
Thank you!! u were right! selecting the rout keep out got the job done.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group