Author Message
 Post subject: wires floating in schmatics
PostPosted: 27 Nov 2013, 05:44 
Offline

Joined: 29 Oct 2013, 16:01
Posts: 3
I see that it is possible to end a wire on the schematics, which is not connected at the end.
Can this be eliminated (that is, if I end the wire, it must be connected to a pin or some off-page connector)?
It can happened that visually it is connected, but actually it is not.
Thanks


Top
 Profile  
 
 Post subject: Re: wires floating in schmatics
PostPosted: 28 Nov 2013, 09:35 
Offline
Technical Support

Joined: 14 Jun 2010, 06:43
Posts: 2762
You can find floating wires in Schematic using Verification -> Electrical rule check. Before starting the verification, please open ERC setup and make sure that pin superimposing option was enabled.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group