Author Message
 Post subject: PCB Dual Trace
PostPosted: 06 Nov 2013, 14:44 

Joined: 03 Sep 2013, 16:59
Posts: 2
Is there a way to create a trace that exists on multiple layers using auto route (meaning multiple smaller traces to the same point instead of one single wider trace). Even if the trace doesn't route the same path as long as it starts and ends at the same point. The reason I ask is I have a header that will not allow me to use the correct trace width for the current needed. Instead I normally run two to three traces to a point that are smaller in width. The problem is I have to do it by hand I would prefer auto route does it for me then I can move and adjust them as needed.


 Post subject: Re: PCB Dual Trace
PostPosted: 08 Nov 2013, 09:29 
Technical Support

Joined: 14 Jun 2010, 06:43
Posts: 2762
Autorouter can't do multiple thin traces on multiple layers instead one wide trace, but you can do it manually.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 4 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group