Author Message
 Post subject: Copper pour needed both sides?
PostPosted: 07 Jul 2013, 12:51 
Offline

Joined: 12 Jun 2013, 11:43
Posts: 9
I'm designing a 100x128mm board and have a copper pour on one side covering 1/2 the board connected to ground. Planning to use ElectroFreaks for a proto run using 1.6mm thick board material.

To prevent warping during board fab do I need to also create a pour on the other side? (I saw mention of this on another PCB design site).

Thanks,
Chris


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group