Author Message
 Post subject: Autoroute attributes ?
PostPosted: 16 Oct 2010, 18:45 

Joined: 16 Oct 2010, 18:33
Posts: 3
I have gone through the tutorial (manual) in pretty good detail, and don't see anyway I can specify autoroute rules for individual nets or groups of nets.

ie. Clock nets, can I tell the autorouter to route specific net/s on a specific layer with length/width/separation/via/ constraints?
ie. Can I tell the autorouter a net or group of nets has to less than a specific length?
ie. Can I tell the autorouter that certain nets have to be equal lengths or within a certain window?
ie. Can I tell the autorouter there are keepout zones around components either graphically or maybe in the pattern tool?

I think you get the idea of what I am after.

I wouldn't be surprised if this tool based on its low cost doesn't have these features.


 Post subject: Re: Autoroute attributes ?
PostPosted: 18 Oct 2010, 02:50 

Joined: 19 Jul 2010, 16:33
Posts: 126
You can draw route keepout zones in a pattern or in the layout.

You could manually route critical things such as power distribution manually.

You could route some nets, and then change the design rules and route other nets. I figure that these are not everything you were looking for, but they are some of the things you might want.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 3 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group