DipTrace Forum
http://www.diptrace.com/forum/

Newbie that needs help...
http://www.diptrace.com/forum/viewtopic.php?f=2&t=11805
Page 1 of 1

Author:  TommyR [ 18 Sep 2017, 13:08 ]
Post subject:  Newbie that needs help...

I'm trying to lean using the free DipTrace.

I'm at the schematic.
Can't even find a generic Op Amp.

Do I look for it while in the schematic area or in the component editor?

-Tom

Author:  Tomg [ 18 Sep 2017, 14:07 ]
Post subject:  Re: Newbie that needs help...

A search can be performed in the Schematic Editor. If you only need a symbol there are four variations in the "Symbols" library (look for "AMPLIFIER"). These are only schematic symbols without attached patterns, but you can attach a pattern if required.

If you need a specific manufacturer and part number, you can use the search filter to find a matching part that might be in the standard libraries. In the Place Component window on the left side of the screen, left-click on the Filter panel (below the Library Tools panel) and enter the necessary search info in the fly-out Filter dialog window. Additional search parameters can be enabled using the [+] button.

I recommend going through the included tutorial for at least 45 minutes every other day. This will get you up and running sooner than you realize. There is also a "Video Guided Tour" located here - http://diptrace.com/support/video-guided-tour.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/