DipTrace Forum
http://www.diptrace.com/forum/

How to divide the scheme on two pcb plates?
http://www.diptrace.com/forum/viewtopic.php?f=2&t=11628
Page 1 of 1

Author:  AlexTitov [ 08 Jun 2017, 08:59 ]
Post subject:  How to divide the scheme on two pcb plates?

My scheme is a controller with high-load transistors. I would like put the control part on the one PCB, and the power part on another PCB. What is the best way to do that?
I tried to put my scheme onto two sheets in Schematics and used bus connectors between sheets. But all these go onto single PCB anyway.

I realize that I can divide the scheme into two separate projects. But I hope to export my scheme into some simulator some later so it should be single complete scheme for that.

Author:  Love life [ 23 Aug 2017, 05:37 ]
Post subject:  Re: How to divide the scheme on two pcb plates?

Then you can design two schematics. One is the control module circuit, one is the power module circuit.
Then use the cable link.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/