DipTrace Forum
http://www.diptrace.com/forum/

Auto-Router Problems
http://www.diptrace.com/forum/viewtopic.php?f=2&t=11381
Page 1 of 1

Author:  joedarock [ 13 Jan 2017, 08:43 ]
Post subject:  Auto-Router Problems

I have a 2-sided board 1.5"x 1.5". It consists of about 35 SMD parts (1206's + 1 SOIC-14). I carefully placed the parts in a way that I thought the autorouter would easily route it. I was surprised when the router gave up when only about 20% of the nets were routed. In some cases, connected pads right next to each other didn't get routed and in other cases of pads right next to each other, it produced long, circuitous routes. One look at the result with human eyeballs spotted numerous trivial but unrouted nets. My grids are set to the finest settings and design rules set for 8mil traces/8 mil spacing.

Is this typical performance or is there something I should be looking for as a possible problem?

Joe

Author:  Tomg [ 13 Jan 2017, 16:11 ]
Post subject:  Re: Auto-Router Problems

1) Make sure the layers to be autorouted are Signal layers. The autorouter does not work on Plane layers: Route --> Layer Setup... --> [Signal/Plane]
2) Make sure the autorouter Layer Priority is set to Orthogonal for each layer to be autorouted: Route --> Autorouter Setup... --> [Settings] --> [X] Use Priority Layer Directions

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/