DipTrace Forum
http://www.diptrace.com/forum/

Circular Trace Connections
http://www.diptrace.com/forum/viewtopic.php?f=2&t=11194
Page 1 of 1

Author:  Fatov [ 21 Aug 2016, 11:09 ]
Post subject:  Circular Trace Connections

Hi,
for some reason I have to connect a net to itself / building a circular trace connection.
The problem is, that for example if I try to make this:
Attachment:
1.png

DipTrace removes the redundant part so I get this:
Attachment:
2.png


So how I can prevent this behavior from DipTrace ?

Author:  Tomg [ 21 Aug 2016, 11:56 ]
Post subject:  Re: Circular Trace Connections

1) In the PCB Layout editor, go to the Main Menu, click on Route and then select Route Setup... in the drop-down menu.
2) In the Route Setup dialog window, select the Settings tab, disable Remove Loops (bow tie effect) and click on OK.

Note: Terminate the loop using the [Enter] key.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/