Author Message
 Post subject: How to divide the scheme on two pcb plates?
PostPosted: 08 Jun 2017, 08:59 
Offline

Joined: 08 Jun 2017, 08:41
Posts: 1
My scheme is a controller with high-load transistors. I would like put the control part on the one PCB, and the power part on another PCB. What is the best way to do that?
I tried to put my scheme onto two sheets in Schematics and used bus connectors between sheets. But all these go onto single PCB anyway.

I realize that I can divide the scheme into two separate projects. But I hope to export my scheme into some simulator some later so it should be single complete scheme for that.


Top
 Profile  
 
 Post subject: Re: How to divide the scheme on two pcb plates?
PostPosted: 23 Aug 2017, 05:37 
Offline

Joined: 01 Apr 2017, 02:09
Posts: 6
Then you can design two schematics. One is the control module circuit, one is the power module circuit.
Then use the cable link.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group