DipTrace Forum
http://www.diptrace.com/forum/

DipTrace overview & tutorial
http://www.diptrace.com/forum/viewtopic.php?f=18&t=4643
Page 1 of 1

Author:  jokkebk [ 28 May 2012, 15:27 ]
Post subject:  DipTrace overview & tutorial

Hi all,

(tried initially post this to the news section but that seems to be for Novarm official posts only :)

I just finished a short tutorial outlining the design of a AVR ATtiny2313 breadboard header schematic using DipTrace. I also covered the creation of a simple custom library pattern and component for a ISP programming header:

http://codeandlife.com/2012/05/28/attin ... -diptrace/

All three parts are also available as separate Youtube videos:

http://youtu.be/W1PiSYfVMZw (Schematic capture)
http://youtu.be/Yr8eQt_JjNI (Pattern editor)
http://youtu.be/ohTFYehq9Ig (Component editor)

The tutorial and videos can be freely linked by Novarm in case you find the material useful. I'm also going to do a second part of the tutorial that covers PCB layout from the schematic (with great pictures of the final PCB from Olimex, populated with components).

-Joonas Pihlajamaa

---
http://codeandlife.com

Author:  Mamunur Rahman [ 28 Feb 2014, 14:45 ]
Post subject:  Re: DipTrace overview & tutorial

Why did you not add sound to the clip? With sound the clips would be more interesting. Anyway thanks.

Author:  ashleygull [ 31 Dec 2014, 06:04 ]
Post subject:  Re: DipTrace overview & tutorial

I remember an old suggestion to take your tip out of the soldering iron, heat it up with a torch, and apply silver solder to it. The idea is that the silver will not corrode, and the silver melting point is much higher than regular solder, so it won't come off. Silver is also a better heat conductor.

Has anyone tried this?

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/