Author Message
 Post subject: Thru hole defaults
PostPosted: 11 Jul 2013, 08:40 
Offline

Joined: 11 Jul 2013, 08:32
Posts: 1
I Fabricated my first ever PCB recently and the board worked just fine but I see I have a few improvements to make before I try it again.


For this first board I used all the defaults for setup.


There are basically three things I need to change to make my thru hole boards easier to assemble by hand The drill holes were on the small side as were the pads, the traces were a little too thin and the space around the pads was too small.


So my questions is which of the setup options in diptrace should be used for thru hole technology that could be considered standard

_________________
R+


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group