Author Message
 Post subject: PCB milling with LPKF ProtMat
PostPosted: 13 May 2013, 15:08 
Offline

Joined: 13 May 2013, 14:40
Posts: 2
I need to mill a board single side in LPKF router. How to configure the export of Gerber files to the format required by CircuitCam?


Top
 Profile  
 
 Post subject: Re: PCB milling with LPKF ProtMat
PostPosted: 14 May 2013, 03:58 
Offline
Technical Support

Joined: 14 Jun 2010, 06:43
Posts: 2760
CircuitCam supports extended Gerber RS-274x and Excellon (i.e. NC drill) files. This means DipTrace Gerber and NC drill files should be imported in CircuitCam without extra actions.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group