Author Message
 Post subject: Plated through holes.
PostPosted: 16 Aug 2012, 09:51 
Offline

Joined: 16 Aug 2012, 09:45
Posts: 1
Most of the boards that I draw are single sided and do not require plated through holes.
Is there any way that I can assign a hole to be not plated through, and with no pads on the top copper.

Any help really appriciated.


Top
 Profile  
 
 Post subject: Re: Plated through holes.
PostPosted: 17 Aug 2012, 09:23 
Offline
Technical Support

Joined: 14 Jun 2010, 06:43
Posts: 2760
All pads are plated in DipTrace. Non-plated are mounting holes only.
If you design single-sided board, just say to PCB fab that all holes should be non-plated.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group