I usually have the pcb house do the panels for me. I would prefer to have more control and do some panels myself.
The panel is straight forward 20R x 2C with B being the border for the panel on each side.
BXXB
BXXB
...
...
The three vertical sections of the board outline are v scored. For this I have created a separate layer, no problem with this based on my reading here.
For the horizontal cut between the boards, I need this milled for a nice clean edge. I have created a nice gap between each row buy how to depict the required milling? I can do a cut out but this seems a bit odd as the cutout would sit outside the board outline....
Thanks in advance
-- 30 Sep 2017, 20:23 --
Bump.
I note that when I draw anything on a new layer is seems to multiply in the gerber file.
See attached, This is a simple vertical line on a new vscore layer. Anyone spot this bug (?) before?
Thanks
Milling Question - Panels
Milling Question - Panels
- Attachments
-
- Capture.JPG (20.77 KiB) Viewed 236 times