DipTrace Forum
http://www.diptrace.com/forum/

DipTrace to TM245P Pick and Place conversion provided here
http://www.diptrace.com/forum/viewtopic.php?f=16&t=10509
Page 1 of 1

Author:  Tony Philipsson [ 27 Jun 2015, 18:34 ]
Post subject:  DipTrace to TM245P Pick and Place conversion provided here

For the new NEODEN TM245P
As the upper left corner of the work area is a fixed point, this most likely will be your starting point and these are the offset for it:
Code:
#Circuit   OffsetX   OffsetY     Skip
10201     -180000   180000       0


When you export a pick and place csv file from Diptrace, if you place the origin at the upper left corner and select Use Design Origin.
Else if you use lower left corner you have to adjust the 180mm OffsetY by subtracting the board height.

If you have panelized, you have to subtract board height(s) + y spacing + panel boarders.

I have attached below a Excel and KingSoft Spreadsheet templates files.
select: new from template, place cursor at H1 and import data, select that it's comma delimited.
It converts the default diptrace export and do: x/y*1000 and change Rotation from 0-360 subtracting 90deg as stack is on the left and then adjusted to -179/180
Don't forget to assign stack now as you can still see the Part's Name
Image

Author:  astropower [ 23 Feb 2016, 10:19 ]
Post subject:  Re: DipTrace to TM245P Pick and Place conversion provided he

Thank you.

Author:  Techno Tronix [ 16 Jul 2016, 06:46 ]
Post subject:  Re: DipTrace to TM245P Pick and Place conversion provided he

Is this similar to TVM802A?

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/