As the upper left corner of the work area is a fixed point, this most likely will be your starting point and these are the offset for it:
Code: Select all
#Circuit OffsetX OffsetY Skip
10201 -180000 180000 0
Else if you use lower left corner you have to adjust the 180mm OffsetY by subtracting the board height.
If you have panelized, you have to subtract board height(s) + y spacing + panel boarders.
I have attached below a Excel and KingSoft Spreadsheet templates files.
select: new from template, place cursor at H1 and import data, select that it's comma delimited.
It converts the default diptrace export and do: x/y*1000 and change Rotation from 0-360 subtracting 90deg as stack is on the left and then adjusted to -179/180
Don't forget to assign stack now as you can still see the Part's Name