DipTrace to TM245P Pick and Place conversion provided here

Preparing layout for manufacturing, Requirements, Verifications. PCB manufacturing process. Feedback about manufacturers.
Post Reply
Message
Author
Tony Philipsson
Posts: 32
Joined: 11 Jul 2011, 12:27

DipTrace to TM245P Pick and Place conversion provided here

#1 Post by Tony Philipsson » 27 Jun 2015, 11:34

For the new NEODEN TM245P
As the upper left corner of the work area is a fixed point, this most likely will be your starting point and these are the offset for it:

Code: Select all

#Circuit   OffsetX	OffsetY	  Skip
10201	  -180000	180000	    0
When you export a pick and place csv file from Diptrace, if you place the origin at the upper left corner and select Use Design Origin.
Else if you use lower left corner you have to adjust the 180mm OffsetY by subtracting the board height.

If you have panelized, you have to subtract board height(s) + y spacing + panel boarders.

I have attached below a Excel and KingSoft Spreadsheet templates files.
select: new from template, place cursor at H1 and import data, select that it's comma delimited.
It converts the default diptrace export and do: x/y*1000 and change Rotation from 0-360 subtracting 90deg as stack is on the left and then adjusted to -179/180
Don't forget to assign stack now as you can still see the Part's Name
Image
Attachments
DIP_to_TM245P.zip
Spreadsheet Templete
(11.89 KiB) Downloaded 55 times

astropower
Posts: 1
Joined: 23 Feb 2016, 03:13

Re: DipTrace to TM245P Pick and Place conversion provided he

#2 Post by astropower » 23 Feb 2016, 03:19

Thank you.

Techno Tronix
Posts: 188
Joined: 09 Jan 2015, 19:00
Location: Anaheim, CA 92806
Contact:

Re: DipTrace to TM245P Pick and Place conversion provided he

#3 Post by Techno Tronix » 15 Jul 2016, 23:46

Is this similar to TVM802A?

Post Reply