Author Message
 Post subject: thermal vias
PostPosted: 11 Aug 2014, 21:17 

Joined: 23 Feb 2014, 23:35
Posts: 10
Hi, OSHPark says they support tenting on thermal vias. So how would I go about tenting with solder mask over the vias in a thermal pad? Since vias are not supported as part of the pattern, I add static vias in the pad and connect them to the pad. This results in the bottom layer tented, but leaves the pad surface open. Is there anyway I can specify a circle of mask over the center of the via?


-- 11 Aug 2014, 20:06 --

Oh and just another note. I tried making overlaying through hole pads on the thermal pad to create vias. It complains about them having the same number, but is is similar to static vias. It seems all mask options are mask additive, there is no way to subtract the through-hole pin mask.

 Post subject: Re: thermal vias
PostPosted: 27 Jun 2015, 23:21 

Joined: 11 Jul 2011, 19:27
Posts: 32
Tenting the bottom is not recommended as gas-out can happen, though not tenting bottom and it can create a wicking effect.
Tenting the top layer of the via is hard, as even if you disable soldermask for the via, the soldermask for the pad itself will override it.

So somehow the custom made pad with open circles where the via's goes needs to be made, but how?

 Post subject: Re: thermal vias
PostPosted: 30 Oct 2015, 07:40 

Joined: 10 Jan 2015, 02:00
Posts: 188
Location: Anaheim, CA 92806
Solder going though the holes and causing voids (not shorts) is said to not be a problem if the via hole diameter is kept to 0.3mm or less. Spacing of 1mm is suggested, and of course the vias should not have thermal reliefs.

PCB Manufacturing

 Post subject: Re: thermal vias
PostPosted: 30 Oct 2015, 07:56 

Joined: 08 Oct 2015, 08:06
Posts: 9
Location: San Diego, CA
Open copper pour properties, go to connectivity tab and verify thermal settings.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group