DipTrace Forum

Page 1 of 1

Author:  MonGater [ 23 Jun 2014, 02:41 ]
Post subject:  Anti-Aliasing

The new Free rotate feature had made it obvious, Anti-Aliasing should make the pattern and component more realistic and professional.

Author:  mtripoli [ 23 Jun 2014, 11:12 ]
Post subject:  Re: Anti-Aliasing

I did a quick test to see if this "carries over" to the Gerbers (at the end of the day, these are all that matter) and unfortunately it appears as if the aliasing persists (using Pentalogix ViewMate Gerber viewer). I did not get a chance to print the test on paper. If the aliasing shows up on the PCB, of course, this is unacceptable.

Author:  MonGater [ 25 Jun 2014, 22:22 ]
Post subject:  Re: Anti-Aliasing

This is how it look like on a PDF printout (same result on paper 1:1)... this is a small footprint SOT666. 6400% zoom-in.

Author:  PedroDaGr8 [ 06 Jul 2014, 22:15 ]
Post subject:  Re: Anti-Aliasing

I think this should be posted in the appropriate section as it might be an important bug

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group