DipTrace Forum
http://www.diptrace.com/forum/

Panelizing support for milling slots and rat bite bridges
http://www.diptrace.com/forum/viewtopic.php?f=11&t=11568
Page 1 of 1

Author:  ulfjar [ 25 Apr 2017, 11:22 ]
Post subject:  Panelizing support for milling slots and rat bite bridges

When the PCB board have components near the PCB boards edges, I want support for panelizing with milling slots and rat bite bridges. V-cut is not good enough....

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/