DipTrace Forum
http://www.diptrace.com/forum/

3D Model Views XYZ
http://www.diptrace.com/forum/viewtopic.php?f=11&t=10624
Page 1 of 1

Author:  dipicorg [ 11 Sep 2015, 06:27 ]
Post subject:  3D Model Views XYZ

It would be nice to have Buttons to set X-Y-Z Orientations 90°-wise. Using the Mouse to move/rotate isn't very eays if you want to see the Model/PCB in a special way (FRONT/SIDE/BACK etc.)

In the PCB Print Preview there is no Option to change the Paper Orientation. Please add it.
It would be nice to have Profiles of the shown Options (Ratlines/Tables/Pads => ON,OFF)

Author:  Serg [ 14 Sep 2015, 08:50 ]
Post subject:  Re: 3D Model Views XYZ

Hello,

Thank you for report. We will think about it.

Serg Luts
DipTrace Team

Author:  farley [ 15 Sep 2015, 07:31 ]
Post subject:  Re: 3D Model Views XYZ

In addition, it would also be helpful that the x, y, z views are shown as orthogonal projections without perspective. This feature (x, y, z views and no perspective) would also be useful in the 3D view in the pattern editor when adding and aligning the 3D models to the pattern.

Author:  Serg [ 16 Sep 2015, 06:57 ]
Post subject:  Re: 3D Model Views XYZ

farley wrote:
In addition, it would also be helpful that the x, y, z views are shown as orthogonal projections without perspective. This feature (x, y, z views and no perspective) would also be useful in the 3D view in the pattern editor when adding and aligning the 3D models to the pattern.


Thank you for offering. But now we do not plan to make it. May be in a future.

Serg Luts
DipTrace Team

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/