Pads and milling not plated

Post here your comments, suggestions and problems
Post Reply
Message
Author
Gigatrek
Posts: 48
Joined: 04 Mar 2014, 01:24

Pads and milling not plated

#1 Post by Gigatrek » 20 Nov 2014, 01:53

When you are drawing a compact PCB with hazardous areas (hight voltage) near low voltage areas it would be useful use not plated miilings.

I see that it's possible make pads with oval drill, but it's not possible make mounting hole with oval drill.

I think that this could be a simply way to solve problem, the best could be have milling tools and make millings as like draw polyline.

Thank you for the attention, i hope to give you a good idea.

Best regards

-- 20 Nov 2014, 17:47 --

I know, thanks to Alex, this request is just present in Dip trace, the way is posted in the topic "Milling on PCB".

Best regards

Post Reply